Rear Airbag Sensor: Installation

INSTALL REAR AIRBAG SENSOR LH
1. Check that the engine switch is off.
2. Check that the cable is disconnected from the battery negative (-) terminal.
  CAUTION: Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to prevent airbag and seat belt pretensioner activation.
3. Install the rear airbag sensor with the bolt.
  Torque: 9.0 N*m (92 kgf*cm, 80 in.*lbf)
  
  Fig 1: Locating Bolt And Rear Airbag Sensor
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
  NOTE:
  - If the rear airbag sensor has been dropped, or there are any cracks, dents or other defects in the case, bracket or connector, replace it with a new one.
  - When installing the rear airbag sensor, be careful that the SRS wiring does not interfere with other parts and that it is not pinched between other parts.
4. Check that there is no looseness in the installation parts of the rear airbag sensor.
5. Connect the connector.
INSTALL REAR SEAT SIDE GARNISH LH (See INSTALLATION )
INSTALL REAR DOOR SCUFF PLATE LH (See INSTALLATION )
INSTALL REAR SEATBACK ASSEMBLY LH (for Fixed Seat Type) (See INSTALLATION )
INSTALL REAR SEATBACK ASSEMBLY LH (for Ottoman) (See INSTALLATION )
INSTALL REAR SEATBACK ASSEMBLY LH (for Power Seat) (See INSTALLATION )
INSTALL REAR SEAT CUSHION ASSEMBLY (for Fixed Seat Type) (See INSTALLATION )
INSTALL REAR SEAT CUSHION ASSEMBLY LH (for Ottoman) (See INSTALLATION )
INSTALL REAR SEAT CUSHION ASSEMBLY LH (for Power Seat) (See INSTALLATION )
CONNECT CABLE TO NEGATIVE BATTERY TERMINAL
PERFORM INITIALIZATION
1. Perform initialization (see INITIALIZATION ).
  NOTE: Certain systems need to be initialized after disconnecting and reconnecting the cable from the negative (-) battery terminal.
CHECK SRS WARNING LIGHT
1. Check the SRS warning light (see DIAGNOSIS SYSTEM ).