Oil Pressure Check

WARNING: This page is about a different car, the 2004 Nissan Quest. However, it is still accessible from the selected car via links, so may be relevant.

WARNING:

Be careful not to burn yourself, as engine oil may be hot.
Put the selector lever in the Park "P" position.

Check the oil level. Refer to "OIL LEVEL ".
Disconnect the oil pressure switch harness connector.
Remove the oil pressure switch.
Install Tools.

Fig 1: Identifying Tool (Pressure Gauge)
Courtesy of NISSAN MOTOR CO., U.S.A.
Start the engine and warm it up to normal operating temperature.

Check oil pressure with engine running under no-load.

ENGINE OIL PRESSURE SPECIFICATION

Engine Speed	Approximate Discharge Pressure
Idle speed	More than 98 kPa (1.0 kg/cm² , 14 psi)
2,000 rpm	294 kPa (3.0 kg/cm² , 43 psi)

CAUTION: If the difference is extreme, check the oil passages and oil pump for leaks and blockages.

After the inspections, install the oil pressure switch as follows:

Remove the old sealant adhering to switch and engine.
Apply thread sealant and tighten the oil pressure switch to specification using Tool.
- Use Genuine High Performance Thread Sealant, or equivalent. Refer to RECOMMENDED CHEMICAL PRODUCTS AND SEALANTS .

Oil pressure switch: 14.8 N.m (1.5 kg-m, 11 ft-lb)