Removal and Installation: Installation

WARNING: This page is about a different car, the 2007 Nissan Quest. However, it is still accessible from the selected car via links, so may be relevant.

Installation is in the reverse order of removal. Note the following:

Refer to "REMOVAL AND INSTALLATION " for tightening torques.
CAUTION: Do not reuse non-reusable parts.
When installing wheel hub and bearing assembly to steering knuckle, align cutout in toner ring cover with wheel sensor mounting hole in steering knuckle.
When installing disc rotor on wheel hub and bearing assembly, align the marks.
(When not using the alignment mark, refer to "DISC ROTOR INSPECTION ").

Fig 1: Identifying Alignment Marks On Disc Rotor And Wheel Hub
Courtesy of NISSAN MOTOR CO., U.S.A.