Inspection Procedure

HINT:

Read freeze frame data using the Intelligent tester or Techstream. Freeze frame data records the engine condition when malfunctions are detected. When troubleshooting, freeze frame data can help determine if the vehicle was moving or stationary, if the engine was warmed up or not, if the air-fuel ratio was lean or rich, and other data from the time the malfunction occurred.

1. PERFORM ACTIVE TEST BY INTELLIGENT TESTER OR TECHSTREAM 
   1. Connect the Intelligent tester or Techstream to the DLC3.
   2. Turn the engine switch on (IG) and turn the tester ON.
   3. Enter the following menus:
      1. Intelligent tester - Select: DIAGNOSIS / ENHANCED OBD II / ACTIVE TEST/ INTAKE CTL VSV1.
      2. Techstream - Select: Powertrain / Engine / Active Test / Activate the VSV for Intake Control.
   4. Check the operation of the intake air control valve actuator using the tester.
      1. Check acoustic control induction system (ACIS)
   1. Perform the Active Test, and check that the actuator link moves.

      OK: Actuator link moves to left and right 

2. Check intake air control valve actuator
   1. Disconnect the actuator link.
   2. Perform the Active Test, and check that the actuator shaft moves.

      OK: Actuator shaft moves to left and right 

      Result 

      RESULT CHART
      
      

      Check ACIS	Check intake air control valve actuator	Proceed to
      NG	NG	A
      OK	OK	B
      NG	OK	C

   B: CHECK FOR INTERMITTENT PROBLEMS (See  CHECK FOR INTERMITTENT PROBLEMS  ) 

   C: REPLACE INTAKE MANIFOLD  (See REMOVAL )

   A: GO TO NEXT STEP 

3. INSPECT INTAKE AIR CONTROL VALVE ACTUATOR 
   1. Disconnect the E46 intake air control valve actuator circuit.
   2. When battery voltage is alternately applied to terminal 1 and 2 of the intake air control valve actuator, check that the actuator shaft moves.
      Fig 1: Identifying Intake Air Control Valve Actuator

      Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

      OK: Actuator shaft moves to left and right 

   NG: REPLACE INTAKE AIR CONTROL VALVE ACTUATOR  (See REMOVAL )

   OK: GO TO NEXT STEP 

4. CHECK HARNESS AND CONNECTOR (INTAKE AIR CONTROL VALVE ACTUATOR - ECM) 
   1. Disconnect the E46 intake air control valve actuator connector.
   2. Disconnect the E4 ECM connector.
   3. Measure the resistance according to the value(s) in the table below.

      Standard resistance (Check for open) 

      INTAKE AIR CONTROL VALVE ACTUATOR - ECM (CHECK FOR OPEN)
      
      

      Tester Connection	Condition	Specified Condition
      E46-2 - E4-7 (ACM+)	Always	Below 1 Ω
      E46-1 - E4-6 (ACM-)	Always

      Standard resistance (Check for short) 

      INTAKE AIR CONTROL VALVE ACTUATOR - ECM (CHECK FOR SHORT)
      
      

      Tester Connection	Condition	Specified Condition
      E46-2 or E4-7 (ACM+) - Body ground	Always	10 kΩ or higher
      E46-1 or E4-6 (ACM-) - Body ground	Always

      Fig 2: Identifying Connector Terminal Of E46 Intake Air Control Valve Actuator

      Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

   NG: REPAIR OR REPLACE HARNESS OR CONNECTOR 

   OK: REPLACE ECM (See  REMOVAL  )