Hood Lock Control Cable Assembly: Installation

HINT:

A bolt without a torque specification is shown in the standard bolt chart (see STANDARD BOLT ).

1. INSTALL HOOD LOCK CONTROL CABLE ASSEMBLY 
   1. Pass the cable into the engine room.
   2. Pass the cable rear side through the grommet until the cable stopper is attached to the grommet.
   3. Pass the cable front side through the upper radiator support.
      Fig 1: Identifying Hood Lock Control Cable

      Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
   4. Connect the clamps as shown in the illustration.
      Fig 2: Connecting Clamps

      Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
2. INSTALL HOOD LOCK CONTROL LEVER SUB-ASSEMBLY 
   1. Install the hood lock lever and connect the hood lock control cable.
   2. Attach the 2 claws.
      Fig 3: Identifying Hood Lock Control Lever Sub-Assembly

      Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
3. INSTALL HOOD LOCK ASSEMBLY 
   1. Apply MP grease to the sliding areas of the lock.
      Fig 4: Applying MP Grease To Sliding Areas Of Lock

      Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
   2. Connect the hood lock control cable.
      Fig 5: Identifying Hood Lock Assembly

      Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
   3. Install the hood lock.
   4. Install the 2 bolts and nut.

      Torque: 8.0 N*m (82 kgf*cm, 71 in.*lbf) 

   5. Install a new cap.
4. INSTALL FRONT FENDER PROTECTOR UPPER LH 
   1. Attach the 3 clips to install the protector.
      Fig 6: Identifying Front Fender Protector Upper LH

      Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
5. INSTALL HOOD LOCK CONTROL CABLE COVER 
   1. Attach the claw to install the cable cover.
   2. Install the 3 screws.
   Fig 7: Identifying Hood Lock Control Cable Cover Claw
   Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
6. INSTALL MILLIMETER WAVE RADAR SENSOR ASSEMBLY  (See INSTALLATION )
7. ADJUST MILLIMETER WAVE RADAR SENSOR ASSEMBLY  (See ADJUSTMENT )
8. INSTALL RADIATOR GRILLE ASSEMBLY  (See INSTALLATION )
9. INSTALL COOL AIR INTAKE DUCT SEAL  (See INSTALLATION )
10. INSTALL AIR CLEANER INLET COVER SUB-ASSEMBLY  (See INSTALLATION )
11. INSTALL ENGINE ROOM SIDE COVER RH  (See INSTALLATION )
12. INSTALL ENGINE ROOM SIDE COVER LH  (See INSTALLATION )
13. INSTALL COWL TOP VENTILATOR LOUVER RH  (See INSTALLATION )
14. PERFORM INITIALIZATION 
    1. Perform initialization (see INITIALIZATION ).
       NOTE: Certain systems need to be initialized after disconnecting and reconnecting the cable from the negative (-) battery terminal.