Stereo Jack Adapter Assembly: Removal

REMOVE COWL TOP VENTILATOR LOUVER RH (See REMOVAL )
DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL
CAUTION: Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to prevent airbag and seat belt pretensioner activation.

NOTE: After the engine switch is turned off, the HDD navigation system requires approximately 6 minutes to record various types of memory and settings. As a result, after turning the engine switch off, wait 6 minutes or more before disconnecting the cable from the negative (-) battery terminal.
REMOVE INSTRUMENT PANEL FINISH PANEL END RH (See REMOVAL )
REMOVE INSTRUMENT PANEL FINISH PANEL END LH (See REMOVAL )
REMOVE SHIFT LEVER KNOB SUB-ASSEMBLY (See REMOVAL )
REMOVE NO. 3 BOX PANEL (See REMOVAL )
REMOVE REAR CONSOLE PANEL UPPER (See REMOVAL )
REMOVE CONSOLE PANEL SUB-ASSEMBLY UPPER (See REMOVAL )
REMOVE CONSOLE BOX POCKET LOWER
1. Disconnect the connector.
2. Detach the 8 claws and remove the console box pocket lower.
  
  Fig 1: Identifying Console Box Pocket Lower Claws
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
REMOVE STEREO JACK ADAPTER ASSEMBLY
1. Detach the 2 claws and remove the adapter.
  
  Fig 2: Locating Stereo Jack Adapter Assembly Claws
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
REMOVE CONSOLE BOX POCKET LOWER (for Ottoman)
1. Disconnect the connector.
2. Detach the 8 claws and remove the console box pocket lower.
  
  Fig 3: Identifying Console Box Pocket Lower Claws
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
REMOVE STEREO JACK ADAPTER ASSEMBLY (for Ottoman)
1. Detach the 2 claws and remove the adapter.
  
  Fig 4: Locating Stereo Jack Adapter Assembly Claws
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002