Satellite Radio Tuner: Installation

HINT:

A bolt without a torque specification is shown in the standard bolt chart (see SPECIFIED TORQUE FOR STANDARD BOLTS ).

1. INSTALL NO. 1 SATELLITE RADIO TUNER BRACKET 
   1. Set the bracket's aligning protrusions labeled A into the tuner holes.
   2. Install the bracket with the 2 bolts labeled B.
   Fig 1: Locating No. 1 Satellite Radio Tuner Bracket Bolts
   Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
2. INSTALL NO. 2 SATELLITE RADIO TUNER BRACKET 
   1. Set the bracket's aligning protrusions labeled A into the tuner holes.
   2. Install the bracket with the 2 bolts labeled B.
      Fig 2: Locating No. 2 Satellite Radio Tuner Bracket Bolts

      Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
3. INSTALL SATELLITE RADIO TUNER ASSEMBLY WITH BRACKET 
   1. Install the tuner with the 3 nuts.
   Fig 3: Locating Satellite Radio Tuner Assembly With Bracket Nuts
   Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
   2. Connect the connectors.
4. INSTALL LUGGAGE COMPARTMENT TRIM COVER ASSEMBLY RH  (See INSTALLATION )
5. INSTALL NO. 1 COOLER COVER (w/ Rear Cooler)  (See INSTALLATION )
6. INSTALL LUGGAGE COMPARTMENT TRIM COVER FRONT  (See INSTALLATION )
7. INSTALL LUGGAGE COMPARTMENT NO. 2 TRIM HOOK (w/o Rear Cooler)  (See INSTALLATION )
8. INSTALL LUGGAGE COMPARTMENT NO. 1 LIGHT ASSEMBLY  (See INSTALLATION )
9. INSTALL REAR FLOOR FINISH PLATE  (See INSTALLATION )
10. INSTALL DECK TRIM SIDE BOARD RH  (See INSTALLATION )
11. INSTALL ROPE HOOK  (See INSTALLATION )
12. INSTALL ROPE HOOK ASSEMBLY  (See INSTALLATION )
13. INSTALL LUGGAGE COMPARTMENT MAT SUB-ASSEMBLY  (See INSTALLATION )
14. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL 
15. INSTALL COWL TOP VENTILATOR LOUVER RH  (See INSTALLATION )
16. PERFORM INITIALIZATION 
    1. Perform initialization (see INITIALIZATION ).
       NOTE: Certain systems need to be initialized after disconnecting and reconnecting the cable from the negative (-) battery terminal.