Rear Upper Arm: Inspection

INSPECT REAR UPPER NO. 1 CONTROL ARM ASSEMBLY LH
1. Temporarily install the nut, and flip the ball joint stud back and forth 5 times as shown in the illustration.
2. Use a torque wrench to turn the nut continuously at a rate of 3 to 5 seconds per turn. Take the torque reading on the fifth turn.
  Standard turning torque:
  
  3.5 N*m (36 kgf*cm, 31 in.*lbf) or less
  
  Fig 1: Inspecting Rear Upper No. 1 Control Arm Assembly LH
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
INSPECT REAR UPPER NO. 2 CONTROL ARM ASSEMBLY LH
1. Temporarily install the nut, and flip the ball joint stud back and forth 5 times as shown in the illustration.
2. Use a torque wrench to turn the nut continuously at a rate of 3 to 5 seconds per turn. Take the torque reading on the fifth turn.
  Standard turning torque:
  
  9.0 N*m (92 kgf*cm, 80 in.*lbf) or less
  
  Fig 2: Inspecting Rear Upper No. 2 Control Arm Assembly LH
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002