Precautions for Harness Repair

WARNING: This page is about a different car, the 2009 Nissan Maxima. However, it is still accessible from the selected car via links, so may be relevant.

Solder the repaired area and wrap tape around the soldered area.

NOTE: A fray of twisted lines must be within 110 mm (4.33 in).

Fig 1: Identifying Soldered And Taped Area OK Position

Courtesy of NISSAN MOTOR CO., U.S.A.

Bypass connection is never allowed at the repaired area.

NOTE: Bypass connection may cause CAN communication error. The spliced wire becomes separated and the characteristics of twisted line are lost.

Fig 2: Identifying Bypass Connection

Courtesy of NISSAN MOTOR CO., U.S.A.

Replace the applicable harness as an assembly if error is detected on the shield lines of CAN communication line.