LEMON Manuals: Even more car manuals for everyone
Home >> Lexus >> 2007 >> IS 250 RWD, Automatic >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 4 (Transfer Case) >> Transfer Wire >> Inspection

Transfer Wire: Inspection

WARNING: This page is about a different variant/trim than selected.
  1. INSPECT TRANSFER WIRE 
    1. Disconnect the transfer wire connector.
    2. Measure the resistance according to the value(s) in the table below.
      Fig 1: Identifying Transfer Transmission Wire Connector
      G05318659Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

      Standard resistance 

      STANDARD RESISTANCE SPECIFICATION

      Tester Connection Specified Condition
      i1-1 - i1-2 5.0 to 5.5 Ω
      i1-1 - Body ground 1 MΩ or higher
      i1-2 -Body ground 1 MΩ or higher

      If the resistance is not specified, replace the transfer wire.

scientia non olet · About LEMON Manuals