LEMON Manuals: Even more car manuals for everyone
Home >> Lexus >> 2007 >> IS 250 AWD >> Repair and Diagnosis >> Transmission >> Automatic Trans >> Automatic Transaxle - A760H >> Torque Converter And Drive Plate >> Installation

Torque Converter And Drive Plate: Installation

  1. INSTALL TORQUE CONVERTER CLUTCH ASSEMBLY (See  REMOVAL   ) 
  2. INSTALL TRANSMISSION OIL COOLER (See  INSTALLATION   ) 
  3. INSTALL TRANSMISSION CONTROL SHAFT LEVER LH (See  INSTALLATION   ) 
  4. INSTALL TRANSFER DYNAMIC DAMPER (See  INSTALLATION   ) 
  5. INSTALL REAR NO. 1 ENGINE MOUNTING INSULATOR (See  INSTALLATION   ) 
  6. INSTALL AUTOMATIC WITH TRANSMISSION TRANSFER ASSEMBLY (See  INSTALLATION   ) 
  7. INSTALL WATER BYPASS HOSE (See  INSTALLATION   ) 
  8. INSTALL WIRE HARNESS (See  INSTALLATION   ) 
  9. CONNECT CONNECTOR (See  INSTALLATION   ) 
  10. INSTALL ENGINE REAR MOUNTING MEMBER (See  INSTALLATION   ) 
  11. INSTALL FLOOR SHIFT GEAR SHIFTING ROD SUB-ASSEMBLY (See  INSTALLATION   ) 
  12. INSTALL NO. 1 EXHAUST PIPE SUPPORT BRACKET SUB-ASSEMBLY (See  INSTALLATION   ) 
  13. INSTALL DRIVE PLATE & TORQUE CONVERTER CLUTCH SETTING BOLT (See  INSTALLATION   ) 
  14. INSTALL STARTER ASSEMBLY (See  INSTALLATION  ) 
  15. INSTALL EXHAUST MANIFOLD SUB-ASSEMBLY LH (See  INSTALLATION  ) 
  16. INSTALL FRONT PROPELLER SHAFT ASSEMBLY (See  INSTALLATION  ) 
  17. INSTALL PROPELLER SHAFT WITH CENTER BEARING ASSEMBLY (See  INSTALLATION  ) 
  18. INSTALL OUTSIDE AIR GUIDE PLATE RH (See  INSTALLATION  ) 
  19. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL 
  20. ADJUST SHIFT LEVER POSITION (See  ADJUSTMENT   ) 
  21. INSPECT SHIFT LEVER POSITION (See  ON-VEHICLE INSPECTION   ) 
  22. INSTALL FRONT FLOOR NO. 1 HEAT INSULATOR (See  INSTALLATION  ) 
  23. INSTALL FRONT EXHAUST PIPE ASSEMBLY (See  INSTALLATION  ) 
  24. INSTALL OXYGEN SENSOR (See  INSTALLATION  ) 
  25. INSTALL FRONT CENTER FLOOR BRACE (See  INSTALLATION  ) 
  26. INSTALL NO. 1 REAR FLOOR PANEL BRACE (See  INSTALLATION  ) 
  27. ADD COOLANT 

    (See ON-VEHICLE INSPECTION )

  28. ADD AUTOMATIC TRANSMISSION FLUID 

    (See ADJUSTMENT  )

  29. ADJUST COOLANT 

    (See ON-VEHICLE INSPECTION )

  30. CHECK FOR ENGINE COOLANT LEAKS (See  ON-VEHICLE INSPECTION  ) 
  31. CHECK FOR EXHAUST GAS LEAKS (See  INSTALLATION  ) 
  32. INSTALL ENGINE UNDER COVER 
  33. INSTALL ENGINE ROOM SIDE COVER LH (See  INSTALLATION  ) 
  34. INSTALL COOL AIR INTAKE DUCT SEAL (See  INSTALLATION  ) 
  35. RESET MEMORY 

    (See INITIALIZATION  )

  36. PERFORM INITIALIZATION 

    Some systems need initialization after reconnecting the cable to the negative battery terminal (See INITIALIZATION ).

scientia non olet · About LEMON Manuals