Inspection Procedure

1. Connect the intelligent tester (with CAN VIM) to the DLC3.
2. Turn the power switch ON (IG).
3. Clear the DTC.
4. Check for DTC.

   HINT:

   When DTCs other than U0126 are output, inspect and repair the trouble areas indicated by those DTCs first.

   Result 

   RESULT REFERENCE CHART
   
   

   Result	Proceed to
   DTC U0126 is not output	A
   DTC U0126 is output	B

B:  GO TO ELECTRONICALLY CONTROLLED BRAKE SYSTEM

A: GO TO Next Step 

1. Disconnect the K19 steering angle sensor connector.
2. Measure the resistance of the wire harness side connector.

   Standard resistance 

   TESTER CONNECTION SPECIFIED CONDITION
   
   

   Tester Connection	Condition	Specified Condition
   K19-10 (CANH) - K19-9 (CANL)	Power switch OFF	54 to 69 Ω

   Fig 1: Identifying K19 Steering Angle Sensor Connector Terminals

   Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

NG: REPAIR OR REPLACE STEERING ANGLE SENSOR BRANCH WIRE OR CONNECTOR (CANH, CANL) 

OK: GO TO Next Step 

1. Disconnect the K19 steering angle sensor connector.
2. Measure the resistance of the wire harness side connector.

   Standard resistance 

   TESTER CONNECTION SPECIFIED CONDITION
   
   

   Tester Connection	Specified Condition
   K19-2 (ESS) - Body ground	Below 1 Ω

3. Measure the voltage of the wire harness side connector.

   Standard voltage 

   TESTER CONNECTION SPECIFIED CONDITION
   
   

   Tester Connection	Condition	Specified Condition
   K19-1 (IG) Body ground	Power switch ON (IG)	10 to 14 V

   Fig 2: Identifying K19 Steering Angle Sensor Connector Terminals

   Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

NG: REPAIR OR REPLACE HARNESS OR CONNECTOR 

OK: REPLACE STEERING ANGLE SENSOR