LEMON Manuals: Even more car manuals for everyone
Home >> Lexus >> 2007 >> GS 450h >> Repair and Diagnosis (Single Page) >> Accessories & Equipment >> Communication Devices >> Cellular Communication >> LEXUS Link System >> ECU Power Source Circuit >> Inspection Procedure

Inspection Procedure

  1. INSPECT FUSE (IGN, ECU-B, ACC) 
    1. Remove the ECU-B fuse from the engine room junction block.
    2. Remove the ACC and IGN fuses from the cowl side junction block RH.
    3. Measure the resistance of the fuses.

      Standard resistance: 

      Below 1 Ω 

    NG: REPLACE FUSE 

    OK: GO TO Next Step 

  2. CHECK WIRE HARNESS (MAYDAY ECU - BATTERY AND BODY GROUND) 
    1. Disconnect the U45 ECU connector.
    2. Measure the voltage and resistance of the wire harness side connector.

      Standard voltage 

      VOLTAGE SPECIFICATION

      Tester Connection Condition Specified Condition
      U45-1 (+B) - Body ground Always 10 to 14 V
      U45-13 (IG2) - Body ground Power switch ON (IG) 10 to 14 V
      U45-14 (ACC) - Body ground Power switch ON (ACC) 10 to 14 V

      Standard resistance 

      RESISTANCE SPECIFICATION

      Tester Connection Specified Condition
      U45 - 12 (E)-Body ground Below 1 Ω
      Fig 1: Identifying U45 ECU Connector Terminals
      G05314886Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

    NG: REPAIR OR REPLACE HARNESS AND CONNECTOR 

    OK: REPLACE MAYDAY ECU TOGETHER WITH MAYDAY BATTERY AND THEN PERFORM REGISTRATION 

scientia non olet · About LEMON Manuals