Data List / Active Test
- READ DATA LIST
HINT:
Using the intelligent tester's DATA LIST allows switch, sensor, actuator and other item values to be read without removing any parts. Reading the DATA LIST early in troubleshooting is one way to save time.
- Turn the engine switch off.
- Connect the intelligent tester (with CAN VIM) to the DLC3.
- Turn the engine switch on (IG) and turn the tester ON.
- Check the values by referring to the table below.
DATA LIST REFERENCE
| Tester Display | Measurement Item/Range | Normal Condition | Reference Value | Diagnostic Note |
|---|---|---|---|---|
| VEHICLE SPD | Vehicle speed/ Min.: 0 km/h (0 mph) Max.: 300 km/h (187 mph) |
Vehicle is stopped | 0 km/h (0 mph) | - |
| Vehicle is driven at constant speed | Value does not vary significantly | - | ||
| FR WHEEL SPD | Front RH wheel speed/ Min.: 0 km/h (0 mph) Max.: 655.35 km/h (409.5 mph) |
Vehicle is stopped | 0 km/h (0 mph) | - |
| Vehicle is driven at constant speed | Value does not vary significantly | - | ||
| FL WHEEL SPD | Front LH wheel speed/ Min.: 0 km/h (0 mph) Max.: 655.35 km/h (409.5 mph) |
Vehicle is stopped | 0 km/h (0 mph) | - |
| Vehicle is driven at constant speed | Value does not vary significantly | - | ||
| RR WHEEL SPD | Rear RH wheel speed/ Min.: 0 km/h (0 mph) Max.: 655.35 km/h (409.5 mph) |
Vehicle is stopped | 0 km/h (0 mph) | - |
| Vehicle is driven at constant speed | Value does not vary significantly | - | ||
| RL WHEEL SPD | Rear LH wheel speed/ Min.: 0 km/h (0 mph) Max.: 655.35 km/h (409.5 mph) |
Vehicle is stopped | 0 km/h (0 mph) | - |
| Vehicle is driven at constant speed | Value does not vary significantly | - | ||
| IG SUPPLY | ECU power voltage condition (IG)/ Min.: 0 V Max.: 19.979 V |
Engine switch on (IG) | 10 to 14 V | - |
| PIG SUPPLY | ECU power voltage condition (PIG)/ Min.: 0 V Max.: 19.979 V |
Engine switch on (IG) | 10 to 14 V | - |
| STEERING ANGLE | Steering angle (turning to left is positive)/ Min.: -3072° Max.: 3070.5° |
Move steering wheel to neutral point | Close to 0 | - |
| Rotate steering wheel | Continuously varies | - | ||
| YAW RATE SENS 1 | Yaw rate value/ Min.: -1.7425°red/s Max.: 1.73825°red/s |
Vehicle is stopped | 0°red/s | - |
| Vehicle is turned to right | 0 to -1.7425°red/s | - | ||
| Vehicle is turned to left | 0 to 1.73825°red/s | - | ||
| YAW RATE SENS 2 | Yaw rate value/ Min.: -1.7425°red/s Max.: 1.73825°red/s |
Vehicle is stopped | 0°red/s | - |
| Vehicle is turned to right | 0 to -1.7425°red/s | - | ||
| Vehicle is turned to left | 0 to 1.73825°red/s | - | ||
| G (RIGHT & LEFT) | Left and right G/ Min.: -321.45408 m/s2 Max.: 321.44427 m/s2 |
Vehicle is accelerated or decelerated | Continuously varies | - |
| G (BACK & FORTH) | Front and rear G/ Min.: -321.45408 m/s2 Max.: 321.44427 m/s2 |
Vehicle is accelerated or decelerated | Continuously varies | - |
| ENGINE SPD | Engine rpm/ Min.: 0 rpm Max.: 12800 rpm |
Vehicle is stopped | 0 rpm | - |
| Engine is running at constant speed | Value does not vary significantly | - | ||
| FR TWIST ANGL | Front stabilizer twist angle/ Min.: -2457.6° Max.: 2457.525° |
Vehicle is stopped on level surface | Approximately 0 | - |
| During roll control | Continuously varies | - | ||
| RR TWIST ANGL | Rear stabilizer twist angle/ Min.: -2457.6° Max.: 2457.525° |
Vehicle is stopped on level surface | Approximately 0 | - |
| During roll control | Continuously varies | - | ||
| FR TARGET TORQ | Front control target torque value/ Min.: -3276.8 N*m Max.: 3276.7 N*m |
- | - | - |
| RR TARGET TORQ | Rear control target torque value/ Min.: -3276.8 N*m Max.: 3276.7 N*m |
- | - | - |
| #DTC | Number of diagnosis codes/ Min.: 0 Max.: 255 |
- | Displays DTCs being output | - |