Valve Body Assembly: Installation

WARNING: This page is about a different car, the 2007 Lexus GS 350. However, it is still accessible from the selected car via links, so may be relevant.

INSTALL TRANSMISSION VALVE BODY ASSEMBLY
1. Install the check ball body and spring.
  NOTE: Do not drop the check ball body and spring.
  
  Fig 1: Identifying Check Ball Body And Spring
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
2. Check the accumulator pistons, check ball body and spring as shown in the illustration.
  
  Fig 2: Identifying Accumulator Pistons, Check Ball Body And Spring
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
3. Align the groove of the manual valve with the pin of the lever.
  
  Fig 3: Aligning Groove Of Manual Valve With Pin Of Lever
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
4. Install the 20 bolts.
  Torque: 11 N*m (112 kgf*cm, 8 ft.*lbf)
  
  Bolt length:
  
  36 mm (1.42 in.) for bolt A
  
  25 mm (0.98 in.) for bolt B
  
  45 mm (1.77 in.) for bolt C
  
  50 mm (1.97 in.) for bolt D
Fig 4: Locating Bolts
Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
CONNECT TRANSMISSION WIRE (See PARK / NEUTRAL POSITION SWITCH )
INSTALL VALVE BODY OIL STRAINER ASSEMBLY (See PARK / NEUTRAL POSITION SWITCH )
INSTALL AUTOMATIC TRANSMISSION OIL PAN SUB-ASSEMBLY (See PARK / NEUTRAL POSITION SWITCH )
CONNECT CABLE TO NEGATIVE BATTERY TERMINAL
ADD AUTOMATIC TRANSMISSION FLUID
1. Add automatic transmission fluid (see AUTOMATIC TRANSMISSION FLUID ).
INSTALL NO. 2 ENGINE UNDER COVER
PERFORM RESET MEMORY
1. Perform the RESET MEMORY procedures (A/T initialization) (see MANUAL SHIFTING TEST ).
PERFORM INITIALIZATION
1. Perform initialization (see INITIALIZATION ).
  NOTE: Certain systems need to be initialized after disconnecting and reconnecting the cable from the negative (-) battery terminal.