LEMON Manuals: Even more car manuals for everyone
Home >> Lexus >> 2007 >> GS 430 >> Repair and Diagnosis >> External Pages >> Different car >> Section 2 (Automatic Transaxle - A760E) >> Floor Shift Assembly >> Installation

Floor Shift Assembly: Installation

WARNING: This page is about a different car, the 2007 Lexus GS 350. However, it is still accessible from the selected car via links, so may be relevant.
  1. INSTALL FLOOR SHIFT ASSEMBLY 
    1. Install the floor shift with the 4 bolts.

      Torque: 8.3 N*m (85 kgf*cm, 73 in.*lbf) 

    2. Connect the 2 connectors to the floor shift.
    3. Connect the 6 clamps.
    Fig 1: Locating Floor Shift With Bolts
    G05288268Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
  2. CONNECT FLOOR SHIFT GEAR SHIFTING ROD SUB-ASSEMBLY 
    1. Temporarily tighten the floor shift gear shifting rod with the nut.
      Fig 2: Locating Shift Lever Nut
      G05288267Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

      HINT:

      The rod is tightened to a torque specification in the "ADJUST SHIFT LEVER POSITION" procedure.

      Fig 3: Identifying Shift Lever Position
      G05288297Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
  3. ADJUST SHIFT LEVER POSITION (See  ADJUSTMENT  ) 
  4. INSTALL FRONT FLOOR NO. 1 HEAT INSULATOR (See  INSTALLATION  ) 
  5. INSTALL FRONT EXHAUST PIPE ASSEMBLY 
    1. Install the front exhaust pipe (see INSTALLATION ).
  6. INSTALL NO. 2 ENGINE UNDER COVER 
  7. INSTALL NO. 2 CONSOLE BOX DUCT (See  INSTALLATION  ) 
  8. INSTALL CONSOLE BOX (See  INSTALLATION  ) 
  9. INSTALL CONSOLE BOX REGISTER ASSEMBLY (See  INSTALLATION  ) 
  10. REMOVE CONSOLE BOX PLATE (See  INSTALLATION  ) 
  11. INSTALL INSTRUMENT PANEL FINISH PANEL END LH (See  INSTALLATION  ) 
  12. INSTALL INSTRUMENT PANEL FINISH PANEL END RH (See  INSTALLATION  ) 
  13. INSTALL CONSOLE UPPER PANEL ASSEMBLY (See  INSTALLATION  ) 
  14. INSTALL FRONT CONSOLE UPPER PANEL GARNISH (See  INSTALLATION  ) 
  15. INSTALL SHIFT LEVER KNOB SUB-ASSEMBLY 
  16. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL 
  17. INSPECT SHIFT LEVER POSITION (See  ON-VEHICLE INSPECTION  ) 
  18. PERFORM INITIALIZATION 
    1. Perform initialization (see INITIALIZATION ).
      NOTE: Certain systems need to be initialized after disconnecting and reconnecting the cable from the negative (-) battery terminal.
scientia non olet · About LEMON Manuals