LEMON Manuals: Even more car manuals for everyone
Home >> Lexus >> 2007 >> GS 430 >> Repair and Diagnosis >> Accessories & Equipment >> Entertainment Systems >> Audio/Visual >> Radio Receiver >> Removal

Radio Receiver: Removal

  1. SET RADIO RECEIVER ASSEMBLY TO SHIPMENT MODE 
    1. Remove all discs and tapes.
      NOTE: If the discs or tapes cannot removed, do not attempt to remove them forcibly. Send the unit to a repair shop.
    2. Turn the engine switch off.
    3. While simultaneously pressing the "SEEK UP" and "DISC" switches, turn the engine switch on (ACC).
      Fig 1: Locating SEEK UP And DISC Switch
      G05300353Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

      HINT:

      The CD loading door indicator light blinks during mode setting and it remains lit after the setting is completed.

      Fig 2: Identifying CD Loading Door Indicator Light Blinking
      G05300354Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
    4. Turn the engine switch off.
  2. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL 
    CAUTION: Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to prevent airbag and seat belt pretensioner activation.
  3. REMOVE FRONT CONSOLE UPPER PANEL GARNISH (See  REMOVAL  ) 
  4. REMOVE CONSOLE UPPER PANEL ASSEMBLY (See  REMOVAL  ) 
  5. REMOVE INSTRUMENT PANEL FINISH PANEL END LH (See  REMOVAL  ) 
  6. REMOVE INSTRUMENT PANEL FINISH PANEL END RH (See  REMOVAL  ) 
  7. REMOVE MULTI-DISPLAY WITH RADIO RECEIVER ASSEMBLY 
    1. Remove the 4 bolts.
      Fig 3: Identifying Multi-Display With Radio Receiver Bolts
      G05299587Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
    2. Pull the multi-display with radio receiver to detach the 2 clips on the backside of the multi-display.
    3. Disconnect the connectors and remove the multi-display with radio receiver.
    Fig 4: Removing Multi-Display With Radio Receiver
    G05299588Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
  8. CONFIRM RADIO RECEIVER ASSEMBLY SHIPMENT MODE SETTING 
    1. Look at the backside of the radio receiver and check that a metal plate can be seen through the hole near the "SHIP" mark.
      NOTE: If a metal plate cannot be seen, perform the shipment mode setting again.
    Fig 5: Identifying Metal Plate Near SHIP Mark
    G05299589Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
  9. REMOVE NO. 2 RADIO BRACKET 
    1. Remove the 5 bolts and bracket.
    Fig 6: Locating Radio No 2 Bracket Bolts
    G05299590Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
  10. REMOVE NO. 1 RADIO BRACKET 
    1. Remove the 5 bolts and bracket.
      Fig 7: Locating Radio No 1 Bracket Bolts
      G05299591Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
  11. REMOVE MULTI-DISPLAY 
  12. REMOVE RADIO RECEIVER ASSEMBLY 
scientia non olet · About LEMON Manuals