DTC Check/Clear

CHECK DTC
1. Connect the intelligent tester to the DLC3.
  1. Connect the intelligent tester to the Controller Area Network Vehicle Interface Module (CAN VIM). Then connect the CAN VIM to the Data Link Connector 3 (DLC3).
2. Turn the engine switch on (IG).
3. Read the DTCs by following the prompts on the tester screen.
  HINT:
  
  Refer to the intelligent tester operator's manual for further details.
CLEAR DTC
1. Connect the intelligent tester to the DLC3.
2. Turn the engine switch on (IG).
3. Operate the intelligent tester to erase the codes.
  HINT:
  
  Refer to the intelligent tester operator's manual for further details.
Fig 1: Connecting Intelligent Tester To DLC3
Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002