Floor Shift Assembly: Installation

INSTALL FLOOR SHIFT ASSEMBLY
1. Install the floor shift with the 4 bolts.
  Torque: 8.3 N*m (85 kgf*cm, 73 in.*lbf)
2. Connect the 2 connectors to the floor shift.
3. Connect the 6 clamps.
Fig 1: Locating Floor Shift With Bolts
Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
CONNECT FLOOR SHIFT GEAR SHIFTING ROD SUB-ASSEMBLY
1. Temporarily tighten the floor shift gear shifting rod with the nut.
  
  Fig 2: Locating Shift Lever Nut
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
  
  HINT:
  
  The rod is tightened to a torque specification in the "ADJUST SHIFT LEVER POSITION" procedure.
  
  Fig 3: Identifying Shift Lever Position
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
ADJUST SHIFT LEVER POSITION (See ADJUSTMENT )
INSTALL FRONT FLOOR NO. 1 HEAT INSULATOR (See INSTALLATION )
INSTALL FRONT EXHAUST PIPE ASSEMBLY
1. Install the front exhaust pipe (see INSTALLATION ).
INSTALL NO. 2 ENGINE UNDER COVER
INSTALL NO. 2 CONSOLE BOX DUCT (See INSTALLATION )
INSTALL CONSOLE BOX (See INSTALLATION )
INSTALL CONSOLE BOX REGISTER ASSEMBLY (See INSTALLATION )
REMOVE CONSOLE BOX PLATE (See INSTALLATION )
INSTALL INSTRUMENT PANEL FINISH PANEL END LH (See INSTALLATION )
INSTALL INSTRUMENT PANEL FINISH PANEL END RH (See INSTALLATION )
INSTALL CONSOLE UPPER PANEL ASSEMBLY (See INSTALLATION )
INSTALL FRONT CONSOLE UPPER PANEL GARNISH (See INSTALLATION )
INSTALL SHIFT LEVER KNOB SUB-ASSEMBLY
CONNECT CABLE TO NEGATIVE BATTERY TERMINAL
INSPECT SHIFT LEVER POSITION (See ON-VEHICLE INSPECTION )
PERFORM INITIALIZATION
1. Perform initialization (see INITIALIZATION ).
  NOTE: Certain systems need to be initialized after disconnecting and reconnecting the cable from the negative (-) battery terminal.