Front Airbag Sensor: Installation

INSTALL FRONT AIRBAG SENSOR
1. Check that the engine switch is off.
2. Check that the battery negative (-) terminal is disconnected.
  CAUTION: After disconnecting the negative battery terminal, wait for at least 90 seconds before starting the operation.
3. Connect the connector.
4. Install the front airbag sensor with the 2 bolts.
  
  Fig 1: Locating Front Airbag Sensor Bolts
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
  
  Torque: 9.0 N*m (92 kgf*cm, 80 in.*lbf)
  NOTE:
  - If the front airbag sensor has been dropped, or there are any cracks, dents or other defects in the case, bracket or connector, replace it with a new one.
  - When installing the front airbag sensor, be careful that the SRS wiring does not interfere with other parts and that it is not pinched between other parts.
5. Check that there is no looseness in the installation parts of the front airbag sensor.
INSTALL HEADLIGHT ASSEMBLY (See INSTALLATION )
INSTALL FRONT BUMPER COVER (See INSTALLATION )
INSTALL COOL AIR INTAKE DUCT SEAL (See INSTALLATION )
CONNECT CABLE TO NEGATIVE BATTERY TERMINAL
PERFORM INITIALIZATION
INSPECT SRS WARNING LIGHT
VEHICLE PREPARATION FOR HEADLIGHT AIM ADJUSTMENT (See ADJUSTMENT )
PREPARATION FOR HEADLIGHT AIMING
1. Preparation for headlight aiming (see ADJUSTMENT ).
HEADLIGHT AIMING INSPECTION (See ADJUSTMENT )
HEADLIGHT AIMING ADJUSTMENT (See ADJUSTMENT )
ADJUST FOG LIGHT AIMING (See REMOVAL )