LEMON Manuals: Even more car manuals for everyone
Home >> Lexus >> 2007 >> GS 350 AWD >> Repair and Diagnosis >> Engine Performance >> Fuel Delivery >> Fuel (2GR-FSE) >> Fuel Pressure Sensor >> Removal

Fuel Pressure Sensor: Removal

  1. PRECAUTION (See  REMOVAL  ) 
  2. DISCHARGE FUEL SYSTEM PRESSURE (See  REMOVAL  ) 
  3. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL 
    CAUTION: Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to prevent airbag and seat belt pretensioner activation.
  4. REMOVE COOL AIR INTAKE DUCT SEAL (See  REMOVAL  ) 
  5. REMOVE ENGINE ROOM SIDE COVER LH (See  REMOVAL  ) 
  6. REMOVE ENGINE ROOM SIDE COVER RH (See  REMOVAL  ) 
  7. REMOVE V-BANK COVER SUB-ASSEMBLY (See  REMOVAL  ) 
  8. REMOVE FRONT PILLAR TO FRONT SIDE SEAL SUB-ASSEMBLY LH (See  REMOVAL  ) 
  9. REMOVE FRONT PILLAR TO FRONT SIDE SEAL SUB-ASSEMBLY RH (See  REMOVAL  ) 
  10. REMOVE FRONT FENDER TO COWL SIDE SEAL LH (See  REMOVAL  ) 
  11. REMOVE FRONT FENDER TO COWL SIDE SEAL RH (See  REMOVAL  ) 
  12. REMOVE FRONT WIPER ARM AND BLADE ASSEMBLY LH (See  REMOVAL  ) 
  13. REMOVE FRONT WIPER ARM AND BLADE ASSEMBLY RH (See  REMOVAL  ) 
  14. REMOVE COWL TOP VENTILATOR LOUVER SUB-ASSEMBLY (See  REMOVAL  ) 
  15. DRAIN ENGINE COOLANT (See  COOLANT  ) 
  16. DISCONNECT NO. 2 VENTILATION HOSE (See  REMOVAL  ) 
  17. REMOVE AIR CLEANER CAP WITH AIR CLEANER HOSE (See  REMOVAL  ) 
  18. REMOVE THROTTLE BODY WITH MOTOR ASSEMBLY (See  REMOVAL  ) 
  19. REMOVE INTAKE AIR SURGE TANK (See  REMOVAL  ) 
  20. REMOVE INTAKE MANIFOLD (See  REMOVAL  ) 
  21. DISCONNECT WATER HOSE JOINT (See  REMOVAL  ) 
  22. REMOVE NO. 1 FUEL PIPE (See  REMOVAL  ) 
  23. REMOVE FUEL PRESSURE SENSOR 
    1. Disconnect the connector and clamp.
    2. Remove the fuel pressure sensor and gasket.
    Fig 1: Locating Fuel Pressure Sensor Connector
    G05286987Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
scientia non olet · About LEMON Manuals