Charging (2GR-FSE): Generator: Removal

DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL
CAUTION: Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to prevent airbag and seat belt pretensioner activation.
REMOVE ENGINE UNDER COVER (for 2WD)
REMOVE ENGINE UNDER COVER (for 4WD)
REMOVE COOL AIR INTAKE DUCT SEAL (See REMOVAL )
REMOVE ENGINE ROOM SIDE COVER LH (See REMOVAL )
REMOVE ENGINE ROOM SIDE COVER RH (See REMOVAL )
REMOVE V-BANK COVER (See REMOVAL )
DISCHARGE REFRIGERANT FROM REFRIGERATION SYSTEM (See REPLACEMENT )
REMOVE NO. 1 AIR CLEANER INLET (See REMOVAL )
DRAIN ENGINE COOLANT (See COOLANT )
REMOVE RADIATOR RESERVOIR ASSEMBLY (See REMOVAL )
REMOVE V-RIBBED BELT (See ON-VEHICLE INSPECTION )
REMOVE NO. 2 IDLER PULLEY SUB-ASSEMBLY
1. Remove the bolt, pulley cover plate and idler pulley.
  
  Fig 1: Locating No.2 Idler Pulley Sub-Assembly Bolt
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
REMOVE COMPRESSOR ASSEMBLY
1. Remove the compressor with pulley for 2WD (see REMOVAL ) or 4WD (see REMOVAL ).
REMOVE GENERATOR ASSEMBLY
1. Detach the clamp, and remove the bolt from the generator.
2. Disconnect the generator connector.
3. Detach the rubber cap, and then remove the nut and battery cable.
  
  Fig 2: Locating Clamp, Bolt, Generator Connector And Battery Cable Nut
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
4. Remove the nut, bolt and generator bracket.
  
  Fig 3: Locating Bracket Bolt And Nut
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
5. Remove the 2 bolts and generator.
  
  Fig 4: Locating Generator Bolts
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002