Inspection Procedure
- CHECK MULTIPLEX COMMUNICATION SYSTEM
Refer to HOW TO PROCEED WITH TROUBLESHOOTING .
If the multiplex communication system is operating normally, proceed to the next step.
- READ VALUE OF INTELLIGENT TESTER
- Connect the intelligent tester to the DLC3.
- Turn the engine switch on (IG).
- Turn the intelligent tester main switch ON.
- Turn the clearance sonar main switch ON.
- Select the item below in the Data List, and read its value displayed on the intelligent tester to check the clearance sonar main switch.
Result
Clearance warning ECU:
RESULT CHARTItem Measurement / Range (Display) Normal Condition Diagnostic Note MAIN SW Clearance sonar main switch / OFF or ON OFF: Clearance sonar main switch OFF
ON: Clearance sonar main switch ON-
OK: PROCEED TO NEXT CIRCUIT INSPECTION SHOWN IN PROBLEM SYMPTOMS TABLE
NG: Go to next step
- READ VALUE OF INTELLIGENT TESTER
- Connect the intelligent tester to the DLC3.
- Turn the engine switch on (IG).
- Turn the intelligent tester main switch ON.
- Turn the clearance sonar main switch ON.
- Select the item below in the Data List, and read its value displayed on the intelligent tester to check the clearance sonar main switch.
Result
Integration control and panel assembly:
PROBLEM SYMPTOMS CHARTItem Measurement / Range (Display) Normal Condition Diagnostic Note SONAR MAIN SW Clearance sonar main switch / OFF or ON OFF: Clearance sonar main switch OFF
ON: Clearance sonar main switch ON-
OK: PROCEED TO NEXT CIRCUIT INSPECTION SHOWN IN PROBLEM SYMPTOMS TABLE
NG: REPLACE INTEGRATION CONTROL AND PANEL ASSEMBLY