Side Airbag Sensor: Removal

HINT:

• Use the same procedures for the RH side and LH side.
• The procedures listed below are for the LH side.

1. PRECAUTION 
   CAUTION: Be sure to read "PRECAUTION " thoroughly before servicing .
2. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL 
   CAUTION: Wait for 90 seconds after disconnecting the cable to prevent airbag deployment.
3. REMOVE FRONT DOOR SCUFF PLATE  (See REMOVAL )
4. REMOVE REAR DOOR SCUFF PLATE  (See REMOVAL )
5. REMOVE LOWER CENTER PILLAR GARNISH  (See REMOVAL )
6. REMOVE SIDE AIRBAG SENSOR 
   1. Remove the nut and separate the side airbag sensor from the body.
   2. Disconnect the side airbag sensor connector and remove it.
      NOTE: When handling the sensor connector, take care not to damage the wire harness.
      Fig 1: Identifying Side Airbag Sensor Connector Nut

      Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002