LEMON Manuals: Even more car manuals for everyone
Home >> Lexus >> 2007 >> ES 350 >> Repair and Diagnosis >> Body & Frame >> Exterior/Interior Trim >> Interior >> Rear Sunshade Assembly >> Installation

Rear Sunshade Assembly: Installation

  1. INSTALL REAR SUNSHADE RELAY 
    NOTE: When reassembling the rear sunshade assembly, eliminate static electricity by touching the vehicle body to prevent the components from being damaged.
    1. Install the rear sunshade relay with the 2 screws.
    2. Connect the connector.
      Fig 1: Locating Connector
      G05254638Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
    3. Engage the 4 claws and install the rear sunshade relay cover.
    4. Install the screw.
      Fig 2: Locating Claws
      G05254637Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
  2. INSTALL REAR WINDOW SHADE ASSEMBLY 
    1. Install the rear window shade assembly, and temporarily tighten the 4 bolts < A > and bolt < B >.
    2. Fully tighten the 5 bolts.
    3. Connect the connector.
      Fig 3: Identifying Rear Window Shade Assembly
      G05254636Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
  3. INSTALL NO. 2 PACKAGE TRAY TRIM PANEL ASSEMBLY 
    1. Engage the 6 claws and 3 clips, and install the No. 2 package tray trim panel assembly.
    Fig 4: Identifying Package Tray Trim Panel Assembly, Clips And Claws
    G05254635Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
  4. INSTALL CENTER STOP LIGHT SET  ( INSTALLATION )
  5. INSTALL PACKAGE TRAY TRIM PANEL ASSEMBLY 
    1. Thread the 3 rear seat belt floor anchors into the package tray trim panel assembly.
    2. Insert the rear end of the package tray trim panel assembly into the rear window shade assembly.
    3. Engage the 2 clips and install the package tray trim panel assembly.
    Fig 5: Identifying Center Stop Light Set
    G05254634Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
  6. INSTALL REAR SEAT SHOULDER BELT HOLE COVER  ( INSTALLATION )
  7. CONNECT REAR SEAT INNER WITH CENTER BELT ASSEMBLY RH  ( INSTALLATION )
  8. CONNECT REAR SEAT 3 POINT TYPE BELT ASSEMBLY LH  ( INSTALLATION )
  9. CONNECT REAR SEAT 3 POINT TYPE BELT ASSEMBLY RH  ( INSTALLATION )
  10. INSTALL ROOF SIDE INNER GARNISH ASSEMBLY LH ( INSTALLATION   ) 
  11. INSTALL ROOF SIDE INNER GARNISH ASSEMBLY RH ( INSTALLATION   ) 
  12. INSTALL REAR SEAT SIDE GARNISH LH (w/o Rear Seat Side Airbag) ( INSTALLATION   ) 
  13. INSTALL REAR SEAT SIDE AIRBAG ASSEMBLY LH (w/ Rear Seat Side Airbag)  ( INSTALLATION )
  14. INSTALL REAR SEAT SIDE GARNISH RH (w/o Rear Seat Side Airbag) ( INSTALLATION   ) 
  15. INSTALL REAR SEAT SIDE AIRBAG ASSEMBLY RH (w/ Rear Seat Side Airbag) 

    HINT:

    Use the same procedure for the LH side and RH side.

  16. INSTALL REAR DOOR SCUFF PLATE LH ( INSTALLATION   ) 
  17. INSTALL REAR DOOR SCUFF PLATE RH ( INSTALLATION   ) 
  18. INSTALL REAR SEATBACK ASSEMBLY  ( INSTALLATION )
  19. INSTALL REAR CENTER SEAT HEADREST ASSEMBLY 
  20. INSTALL REAR SEAT HEADREST ASSEMBLY 
  21. INSTALL REAR SEAT CUSHION ASSEMBLY  ( INSTALLATION )
  22. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL (w/ Rear Seat Side Airbag) 
  23. PERFORM INITIALIZATION (w/ Rear Seat Side Airbag) 
    NOTE: Some systems need initialization after reconnecting the cable to the negative battery terminal ( INITIALIZATION ).
  24. INSPECT SRS WARNING LIGHT (w/ Rear Seat Side Airbag) 

    ( DIAGNOSIS SYSTEM )

scientia non olet · About LEMON Manuals