Mode Description
WARNING: This page is about a different car, the 2006 Toyota 4Runner. However, it is still accessible from the selected car via links, so may be relevant.
SYMPTOM TABLE
| Detection Item |
Symptom |
Trouble Area |
| YAW RATE SENSOR COMMUNICATION STOP MODE |
- "YAW /DECELERAT" is not displayed on the "BUS CHECK" screen of the hand-held tester via the CAN VIM.
- DTCs are output from each ECU in yaw rate sensor communication stop mode as shown in the DTCs are output from each ECU in skid control ECU communication stop mode as shown in "DTC COMBINATION TABLE" under PROBLEM SYMPTOMS TABLE .
|
- Power source or inside the yaw rate sensor
- Yaw rate sensor sub bus line or connector
|