Mode Description
WARNING: This page is about a different car, the 2006 Toyota 4Runner. However, it is still accessible from the selected car via links, so may be relevant.
SYMPTOM TABLE
| Detection Item |
Symptom |
Trouble Area |
| STEERING ANGLE SENSOR COMMUNICATION STOP MODE |
- "STEERING SENSOR" is not displayed on the "BUS CHECK" screen of the hand-held tester via the CAN VIM.
- DTCs are output from each ECU in steering angle sensor communication stop mode as shown in DTCs are output from each ECU in skid control ECU communication stop mode as shown in "DTC COMBINATION TABLE" under PROBLEM SYMPTOMS TABLE .
|
- Power source or inside the steering angle sensor
- Steering angle sensor sub bus line or connector
|