On-Vehicle Inspection

1. Remove the transfer case No. 1 plug and gasket No. 1.
2. Check that the oil level is 0 to 5 mm (0 to 0.1968 in.) below the lower side of the transfer case No. 1 plug hole.
   NOTE:

   • When changing oil, recheck the oil level after driving.
   • Excessively large or small amounts of oil may cause some trouble.
3. When the oil level is too low, check for oil leakage.
4. Tighten the transfer case No. 1 plug with a new gasket No. 1.

Torque: 49 N*m (500 kgf*cm, 36 ft.*lbf) 

1. remove the transfer case No. 1 plug and gasket No. 1 and add the oil.
   NOTE:

   • When checking oil, make sure the vehicle is level.
   • When adding oil, pour it slowly.
   • Add oil several times in interval.

   HINT:

   within 0 to 5 mm (0 to 0.1968 in.) below the lower side of the transfer case No. 1 plug hole.

2. After leaving it alone for 5 minutes, recheck the oil level.
3. Tighten the transfer case No. 1 plug with anew gasket No. 1.

Torque: 49 N*m (500 kgf*cm, 36 ft.*lbf)