On-Vehicle Inspection

1. Remove the case plug (filler plug) and gasket.
2. Check that the oil level is between 0 to 5.0 mm (0 to 0.20 in.) from the bottom lip of the case plug (filler plug) hole.
   Fig 1: Identifying Transfer Oil Level

   Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

   If the result is not as specified, add transfer oil.

   Oil grade: GL-4 or GL-5 

   Viscosity: SAE 75W-90 

   Standard capacity: 1.3 liters (1.4 US qts, 1.1 lmp.qts) 

   NOTE:

   • After changing the oil, drive the vehicle and check the oil level again.
   • Too much or too little oil will lead to transfer problems.
3. When the oil level is too low, check for oil leakage.
4. Install a new gasket into the case plug (filler plug) and then tighten the plug.

Torque: 37 N*m (377 kgf*cm, 27 ft.*lbf) 

1. Remove the case plug (filler plug) and gasket.
2. Pour oil so that the oil level is between 0 to 5.0 mm (0 to 0.20 in.) from the bottom lip of the case plug (filler plug) hole.
   NOTE:

   • When adding oil, pour it slowly.
   • Add oil a little at a time, waiting several minutes between each addition of oil.
3. Wait approximately 5 minutes and check that the oil level has not changed.
4. Install a new gasket and the case plug (filler plug).

Torque: 37 N*m (377 kgf*cm, 27 ft.*lbf)