LEMON Manuals: Even more car manuals for everyone
Home >> Lexus >> 2006 >> IS 250 AWD >> Repair and Diagnosis >> Transmission >> Automatic Trans >> Automatic Transmission (A760H) >> Shift Lock System >> On-Vehicle Inspection

On-Vehicle Inspection

  1. INSPECT SHIFT LOCK SYSTEM 
    1. Check the shift lock operation.
      1. Move the shift lever to the P position.
      2. Turn the engine switch off.
      3. Check that the shift lever cannot be moved to any position other than P.
      4. Turn the engine switch on (IG), depress the brake pedal and check that the shift lever can be moved to the other positions.

      If the operation cannot be done as specified, inspect the shift lock control unit.

    2. Check the shift lock release button operation.
      1. Using a small screwdriver, remove the shift lock release cover.
      2. When operating the shift lever with the shift lock release button pressed, check that the lever can be moved to any position other than P.

      If the operation cannot be done as specified, check the shift lever assembly installation condition.

    3. Check the key interlock operation.
      1. Turn the engine switch on (IG).
      2. Depress the brake pedal and move the shift lever to any position other than P.
    4. Inspect the shift lock control unit assembly.
      1. Measure the voltage according to the value(s) in Fig 1 .

        HINT:

        Do not disconnect the shift lock control unit assembly connector.

        Fig 1: Identifying Shift Lock Switch Connector Terminals
        G04045297Courtesy of TOYOTA MOTOR SALES, U.S.A., INC.

        Standard voltage 

        SHIFT LOCK CONTROL UNIT ASSEMBLY TABLE

        Terminal Measuring Condition Voltage (V)
        7 (STP) - 8 (E) Depress brake pedal 10 to 14
        7 (STP) - 8 (E) Release brake pedal Below 1
        1 (IG) - 8 (E) Engine switch on (IG) 10 to 14
        1 (IG) - 8 (E) Engine switch off Below 1
      2. Measure the resistance according to the value in SHIFT LOCK VOLTAGE TABLE  .

    HINT:

    Do not disconnect the shift lock control unit assembly connector.

    Standard voltage 

    SHIFT LOCK CONTROL UNIT ASSEMBLY TABLE (STANDARD VOLTAGE)

    Terminal Measuring Condition Specified Value
    8 (E) - Body ground Always Below 1 ohms
    Fig 2: Identifying Shift Lock Switch Connector Terminals
    G04045298Courtesy of TOYOTA MOTOR SALES, U.S.A., INC.

    If the operation cannot be done as specified, replace the shift lever assembly.

    If the resistance value is not as specified, replace the shift lock control unit.