License Plate Light Assembly: Installation

WARNING: This page is about a different car, the 2006 Lexus GS 430 and 2006 Lexus GS 300. However, it is still accessible from the selected car via links, so may be relevant.

HINT:

Use the same procedures for the RH side and LH side.
The procedures listed below are for the LH side.

INSTALL BACK DOOR GARNISH RETAINER SUBASSEMBLY
1. Install the 2 clips and retainer to the luggage compartment door.
2. Install the 2 screws.
  
  Fig 1: Identifying Clips And Retainer To Luggage Compartment Door
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
INSTALL LICENSE PLATE LIGHT ASSEMBLY
1. Install the license plate light and 2 screws to the luggage compartment door.
  
  Fig 2: Identifying License Plate Light And Screws To Luggage Compartment Door
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
2. Connect the connector.
INSTALL LUGGAGE COMPARTMENT DOOR GARNISH SUB-ASSEMBLY OUTSIDE (See INSTALLATION )

Fig 3: Locating Connector
Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
INSTALL LUGGAGE DOOR OPENING SWITCH ASSEMBLY
1. Install the switch and 2 screws to luggage compartment door.
2. Connect the connector.
INSTALL LUGGAGE COMPARTMENT DOOR COVER (See INSTALLATION )
CONNECT CABLE TO NEGATIVE BATTERY TERMINAL
PERFORM INITIALIZATION
1. Perform initialization (see INITIALIZATION ).
  NOTE: Certain systems need to be initialized after disconnecting and reconnecting the cable from the negative (-) battery terminal.
  
  Fig 4: Locating Luggage Door Opening Switch Assembly
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002