Yaw Rate Sensor: Installation

WARNING: This page is about a different car, the 2006 Lexus GS 430 and 2006 Lexus GS 300. However, it is still accessible from the selected car via links, so may be relevant.

INSTALL YAW RATE SENSOR
1. Install the yaw rate sensor with the 2 bolts.
  Torque: 15 N*m (153 kgf*cm, 11 ft.*lbf)
  NOTE:
  - Do not damage the yaw rate sensor.
  - Make sure that the yaw rate sensor is installed securely.
2. Install the 2 wire harness clamps.
3. Connect the yaw rate sensor connector.
  
  Fig 1: Identifying 2 Wire Harness Clamps
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
INSTALL CONSOLE BOX NO.1 DUCT
1. Install the console box No.1 duct with the clip.
  
  Fig 2: Identifying Console Box No.1 Duct With Clip
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
INSTALL CONSOLE BOX NO.2 DUCT
1. Install the console box No.2 duct with the 2 clip.
  
  Fig 3: Identifying Console Box No.2 Duct With 2 Clip
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
INSTALL CONSOLE BOX (See INSTALLATION )
INSTALL CONSOLE BOX REGISTER ASSEMBLY (See INSTALLATION )
INSTALL INSTRUMENT PANEL FINISH PANEL END LH (See INSTALLATION )
INSTALL INSTRUMENT PANEL FINISH PANEL END RH (See INSTALLATION )
INSTALL CONSOLE BOX PLATE (See INSTALLATION )
INSTALL FRONT CONSOLE UPPER PANEL ASSEMBLY (See INSTALLATION )
INSTALL CONSOLE UPPER PANEL GARNISH FRONT (See INSTALLATION )
PERFORM YAW RATE SENSOR ZERO POINT CALIBRATION
(See CHECK FOR INTERMITTENT PROBLEMS )
INSPECT VSC SENSOR SIGNAL
(See TEST MODE PROCEDURE )