LEMON Manuals: Even more car manuals for everyone
Home >> Lexus >> 2006 >> GS 430 >> Repair and Diagnosis >> Brakes >> Brakes Control Systems >> Brake Control >> Electronically Controlled Brake System >> DTC C1256/57 Accumulator Low Pressure >> Description

DTC C1256/57 Accumulator Low Pressure: Description

The accumulator pressure sensor is built into the actuator and detects the accumulator pressure. The skid control ECU turns on the brake control warning light and sounds the skid control buzzer if it senses a decrease in the accumulator pressure.

DTC DETECTION CONDITION AND TROUBLE AREA CHART

DTC No. INF Code DTC Detection Condition Trouble Area
C1256/57  141 When either of the following is detected:
  1. When inputting the vehicle speed, the brake operation is input with the accumulator pressure decreased or the accumulator pressure extremely decreases while braking for 0.3 seconds or more.
  2. The accumulator pressure has been low since system start and the pressure is less than 14.62 MPa for 0.8 seconds. (After a condition is met, the code is stored and the buzzer sounds.)
  • Brake actuator assembly
  • Skid control ECU
143 When any of the following is detected:
  1. When inputting the vehicle speed, any of the wheel cylinder pressure sensor values is lower than the specified value with the accumulator pressure low for 0.5 seconds or more.
  2. The accumulator pressure decreases without increasing the wheel cylinder pressure of each wheel.
  3. With the motor relay abnormal or off, the accumulator pressure is less than 14.62 MPa for 0.5 seconds or more.