Height Control Sensor: Removal

HINT:

• Use the same procedures for the RH side and LH side.
• The procedures listed below are for the LH side.

1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL 
   CAUTION: Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to prevent airbag and seat belt pretensioner activation.
2. REMOVE HEIGHT CONTROL SENSOR SUBASSEMBLY FRONT 
   1. Remove the front tire.
   2. Disconnect the connector.
   3. 2WD:

      Remove the nut and sensor link from the lower arm.

      Fig 1: Identifying Nut And Sensor Link From Lower Arm (2WD)

      Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
   4. 4WD:

      Remove the bolt and sensor link from the lower arm.

      Fig 2: Identifying Bolt And Sensor Link From Lower Arm (4WD)

      Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
   5. Remove the 2 bolts and sensor.
3. REMOVE HEIGHT CONTROL SENSOR SUBASSEMBLY REAR 
   1. Remove the rear tire.
   2. Disconnect the connector.
      Fig 3: Identifying Rear Tire

      Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
   3. Put matchmarks on the sensor link and bracket.
      Fig 4: Putting Matchmarks On Sensor Link And Bracket

      Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
   4. Remove the 2 bolts and sensor.
      Fig 5: Identifying Bolts And Sensor

      Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002