LEMON Manuals: Even more car manuals for everyone
Home >> Lexus >> 2006 >> GS 300 RWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 5 (Engine Control System (3UZ-FE)) >> Camshaft Timing Oil Control Valve Assembly >> Installation

Camshaft Timing Oil Control Valve Assembly: Installation

WARNING: This page is about a different car, the 2006 Lexus GS 430. However, it is still accessible from the selected car via links, so may be relevant.
  1. INSTALL CAMSHAFT TIMING OIL CONTROL VALVE ASSEMBLY LH 
    1. Install a new O-ring to the oil control valve.
    2. Install the oil control valve with the bolt.

      Torque: 8.5 N*m (87 kgf*cm, 75 in.*lbf) 

    3. Connect the oil control valve connector.
      Fig 1: Identifying Camshaft Timing Oil Control Valve Assembly LH
      G04027192Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
  2. INSTALL CAMSHAFT TIMING OIL CONTROL VALVE ASSEMBLY RH 
    1. Install a new O-ring to the oil control valve.
    2. Install the oil control valve with the bolt.

      Torque: 8.5 N*m (87 kgf*cm, 75 in.*lbf) 

    3. Connect the oil control valve connector.
      Fig 2: Identifying Oil Control Valve Connector
      G04027193Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
  3. INSTALL INTAKE AIR CONNECTOR PIPE 
    1. Install the intake air connector pipe with the bolt and 2 hose clamps.
      Fig 3: Identifying Intake Air Connector Pipe With Bolt And Hose Clamps
      G04027194Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

      Torque: 4.0 N*m (41 kgf*cm, 35 in.*lbf) for hose clamp 

      5.0 N*m (51 kgf*cm, 44 in.*lbf) for bolt 

    2. Connect the air hose and No. 1 ventilation hose.
  4. INSTALL NO. 1 AIR CLEANER INLET 
    1. Install the air cleaner inlet and bolt.

      Torque: 5.0 N*m (51 kgf*cm, 44 in.*lbf) 

  5. INSTALL V-BANK COVER 
    1. Install the V-bank cover with the 2 nuts.

      Torque: 5.0 N*m (51 kgf*cm, 44 in.*lbf) 

  6. INSTALL ENGINE ROOM SIDE COVER LH 
    1. Install the side cover with the 3 clips.
      Fig 4: Identifying Engine Room Side Cover LH
      G04027195Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
  7. INSTALL ENGINE ROOM SIDE COVER RH 
    1. Install the side cover with the 2 clips and nut.
      Fig 5: Identifying Side Cover With Clips And Nut
      G04027196Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
  8. INSTALL COOL AIR INTAKE DUCT SEAL 
    1. Install the intake duct seal with the 7 clips.
  9. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL 
  10. PERFORM INITIALIZATION 
    1. Perform initialization (INITIALIZATION ).
      Fig 6: Identifying Intake Duct Seal
      G04027197Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
      NOTE: Certain systems need to be initialized after disconnecting and reconnecting the cable from the negative (-) battery terminal.
scientia non olet · About LEMON Manuals