Valve Body Assembly: Installation

WARNING: This page is about a different car, the 2006 Lexus GS 430. However, it is still accessible from the selected car via links, so may be relevant.

INSTALL TRANSMISSION VALVE BODY ASSEMBLY
1. Install the check ball body and spring.
  NOTE: Do not drop the check ball body and spring.
  
  Fig 1: Identifying Check Ball Body And Spring
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
2. Check the accumulator pistons, check ball body and spring as shown in the illustration.
  
  Fig 2: Identifying Accumulator Piston
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
3. Align the groove of the manual valve with the pin of the lever.
  
  Fig 3: Aligning Groove Of Manual Valve With Pin Of Lever
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
4. Install the 20 bolts.
  Torque: 11 N*m (110 kgf*cm, 8 ft.*lbf)
  
  Bolt length:
  
  Bolt A:
  
  36 mm (1.42 in.)
  
  Bolt B:
  
  25 mm (0.98 in.)
  
  Bolt C:
  
  45 mm (1.77 in.)
  
  Bolt D:
  
  50 mm (1.97 in.)
  
  Fig 4: Identifying Bolts
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
CONNECT TRANSMISSION WIRE (See INSTALLATION )
INSTALL VALVE BODY OIL STRAINER ASSEMBLY (See INSTALLATION )
INSTALL AUTOMATIC TRANSMISSION OIL PAN SUB-ASSEMBLY (See PARK / NEUTRAL POSITION SWITCH )
INSTALL ENGINE UNDER COVER AIR GUIDE BRACKET (See PARK / NEUTRAL POSITION SWITCH )
INSTALL EXHAUST PIPE NO.1 SUPPORT BRACKET SUB-ASSEMBLY (See TORQUE CONVERTER AND DRIVE PLATE )
CONNECT CABLE TO NEGATIVE BATTERY TERMINAL
ADD AUTOMATIC TRANSMISSION FLUID
(See AUTOMATIC TRANSMISSION FLUID )
INSTALL ENGINE UNDER COVER NO.2
RESET MEMORY
(See MECHANICAL SYSTEM TESTS )
PERFORM INITIALIZATION
(INITIALIZATION )