Inspection Procedure

CHECK THE BLUETOOTH SETTINGS
1. Check if the BLUETOOTH settings are correct.
  OK: BLUETOOTH settings are correct.
1. NG: SET SETTINGS CORRECTLY
2. OK: Go to next step.
CHECK CELLULAR PHONE
1. Check if the cellular phone is BLUETOOTH capable.
  HINT:
  
  Some versions of BLUETOOTH capable cellular phone may not be compatible.
  
  OK: Phone is BLUETOOTH capable.
1. NG: END (ONLY BLUETOOTH CAPABLE CELLULAR PHONE CAN BE USED)
2. OK: Go to next step.
CHECK SETTINGS
1. Check if the cellular phone functions.
2. Check if the cellular phone functions.
  HINT:
  
  The cellular phone is unable to call under any of the following conditions.
  - The cellular phone is locked.
  - The directory is being transferred.
  - The line is crossed.
  - Transmission is regulated.
  - The power is off.
  - The cellular phone is not connected to BLUETOOTH ("BT" is displayed while connected).
    OK: Above conditions do not exist.
1. NG: SET SETTINGS CORRECTLY
2. OK: Go to next step.
CHECK CELLULAR PHONE
1. Check if the cellular phone can call.
  HINT:
  
  When the battery charge is low, calls cannot be made or received.
  
  OK: Cellular phone can call.
1. NG: REPLACE CELLULAR PHONE
2. OK: Go to next step.
CHECK RECEPTION
1. Set the cellular phone so that it can receive calls.
2. Place the cellular phone close to the multi-display.
3. Check if the cellular phone has reception according to the multi-display.
  OK: Cellular phone has reception.
1. NG: REPLACE MULTI-DISPLAY (See MULTI-DISPLAY (CENTER DISPLAY) )
2. OK: PROCEED TO NEXT CIRCUIT INSPECTION SHOWN IN PROBLEM SYMPTOMS TABLE (See PROBLEM SYMPTOMS TABLE )