License Plate Lamp: Replacement

HINT:

• See COMPONENTS  .
• The installation procedures are the removal procedures in reverse order.
• Use the same procedures for the RH side and LH side.
• The procedures listed below are for the LH side.

1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL 
   CAUTION: Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to prevent airbag and seat belt pretensioner activation.
2. REMOVE LICENSE PLATE LAMP LH 
   1. Disconnect the connector.
   2. Using a screwdriver, remove the lamp.

      HINT:

      Tape the screwdriver tip before use.

      Fig 1: Removing License Plate Lamp LH

      Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
3. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL 
4. PERFORM INITIALIZATION (See  INITIALIZATION  ) 
   NOTE: Certain systems need to be initialized after disconnecting and reconnecting the cable from the negative (-) battery terminal.