Side Airbag Sensor: Removal
WARNING: This page is about a different car, the 2007 Lexus RX 350. However, it is still accessible from the selected car via links, so may be relevant.
HINT:
- Use the same procedures for the RH side and LH side.
- The procedures listed below are for the LH side.
- PRECAUTION CAUTION: Be sure to read the "PRECAUTION" thoroughly before servicing (See PRECAUTION ).
- DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL CAUTION: Wait for 90 seconds after disconnecting the cable to prevent the airbag working.
- REMOVE FRONT DOOR SCUFF LH PLATE (See REMOVAL )
- REMOVE REAR DOOR SCUFF LH PLATE (See REMOVAL )
- REMOVE FRONT DOOR OPENING TRIM LH WEATHERSTRIP
- REMOVE REAR DOOR OPENING TRIM LH WEATHERSTRIP
- REMOVE LAP BELT OUTER ANCHOR COVER (See REMOVAL )
- REMOVE CENTER PILLAR LH GARNISH LOWER
HINT:
(See REMOVAL )
- REMOVE FRONT SEAT OUTER BELT ASSEMBLY (See REMOVAL )
- REMOVE SIDE AIRBAG SENSOR LH
- Remove the 2 bolts and the side airbag sensor LH.
- Disconnect the connector from the side airbag sensor LH.