Side Airbag Sensor: Installation
WARNING: This page is about a different car, the 2007 Lexus RX 350. However, it is still accessible from the selected car via links, so may be relevant.
HINT:
- Use the same procedures for the RH side and LH side.
- The procedures listed below are for the LH side.
- INSTALL SIDE AIRBAG SENSOR LH
- Check that the ignition switch is off.
- Check that the battery negative (-) terminal is disconnected.CAUTION: After disconnecting the negative battery terminal, wait for at least 90 seconds before starting the operation.
- Install the side airbag sensor LH with the 2 bolts.
Torque: 17.5 N*m (179 kgf*cm, 13 ft.*lbf)
NOTE:- If the side airbag sensor LH has been dropped, or there are any cracks, dents or other defects in the case, bracket or connector, replace it with a new one.
- When installing the side airbag sensor LH, be careful that the SRS wiring does not interfere with other parts and that it is not pinched between other parts.
- Check that there is no looseness in the installation parts of the side airbag sensor LH.
- Connect the connector to the side airbag sensor LH.
- INSTALL FRONT SEAT OUTER BELT ASSEMBLY (See INSTALLATION )
- INSTALL CENTER PILLAR LH GARNISH LOWER
HINT:
(See INSTALLATION )
- INSTALL LAP BELT OUTER ANCHOR COVER
HINT:
(See INSTALLATION )
- INSTALL REAR DOOR OPENING TRIM LH WEATHERSTRIP
- INSTALL FRONT DOOR OPENING TRIM LH WEATHERSTRIP
- INSTALL REAR DOOR SCUFF LH PLATE
HINT:
(See INSTALLATION )
- INSTALL FRONT DOOR SCUFF LH PLATE
HINT:
(See INSTALLATION )
- CONNECT CABLE TO NEGATIVE BATTERY TERMINAL
- PERFORM INITIALIZATION
- Perform initialization (See
INITIALIZATION
).
HINT:
Some systems need initialization after reconnecting the cable to the negative battery terminal.
- Perform initialization (See
INITIALIZATION
).
- INSPECT SRS WARNING LIGHT
- Inspect the SRS warning light (See DIAGNOSIS SYSTEM ).