LEMON Manuals: Even more car manuals for everyone
Home >> Lexus >> 2005 >> IS 300 Base, Automatic >> Repair and Diagnosis >> Transmission >> Automatic Trans >> Automatic Transmission (On-Vehicle Service) >> O/D Direct Clutch Speed Sensor >> On-Vehicle Repair

On-Vehicle Repair

  1. REMOVE NO. 1 AND NO. 2 ENGINE UNDER COVERS 
  2. REMOVE LH FRONT FLOOR CENTER COVER 
  3. REMOVE NO. 1 REAR FLOOR BOARD 
  4. DISCONNECT O/D DIRECT CLUTCH SPEED SENSOR CONNECTOR 
    Fig 1: Locating O/D Direct Clutch Speed Sensor
    G02946041Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
  5. REMOVE O/D DIRECT CLUTCH SPEED SENSOR 
    1. Remove the bolt and O/D direct clutch speed sensor.
    2. Remove the O-ring from the O/D direct clutch speed sensor.
  6. INSTALL O/D DIRECT CLUTCH SPEED SENSOR 
    1. Coat a new O-ring with ATF and install it to the O/D direct clutch speed sensor.
    2. Install the O/D direct clutch speed sensor to the transmission case and torque the bolt.
      1. Torque: 5.4 N.m (55 kgf.cm, 48 in.lbf) 
  7. INSTALL NO. 1 REAR FLOOR BOARD 
  8. INSTALL LH FRONT FLOOR CENTER COVER 
  9. INSTALL NO. 1 AND NO. 2 ENGINE UNDER COVERS 
scientia non olet · About LEMON Manuals