Monitor Result (Mode 06 Data): Notes

Refer to PRE-CHECK  for detailed information.

The test value and test limit information are described as shown in the following table. Check the monitor result and test values after performing the monitor drive pattern (see READINESS MONITOR DRIVE PATTERN )

• TID (Test Identification Data) is assigned to each emissions-related component.
• TID (Test Limit Type):

  If TLT is 0, the component is malfunctioning when the test value is higher than the test limit.

  If TLT is 1, the component is malfunctioning when the test value is lower than the test limit.

• CID (Component Identification Data) is assigned to each test value.
• Unit Conversion is used to calculate the test value indicated on generic OBDII scan tools.