LEMON Manuals: Even more car manuals for everyone
Home >> Lexus >> 2004 >> RX 330 FWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 599 (Supplemental Restraint System) >> Seat Position Sensor >> Removal

Seat Position Sensor: Removal

WARNING: This page is about a different car, the 2008 Lexus RX 350. However, it is still accessible from the selected car via links, so may be relevant.
  1. PRECAUTION 
    CAUTION: Be sure to read the "PRECAUTION" thoroughly before servicing (See PRECAUTION  ).
  2. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL 
    CAUTION: Wait for 90 seconds after disconnecting the cable to prevent the airbag working.
    NOTE: When disconnecting the cable, some systems need to be initialized after the cable is reconnected (See INITIALIZATION ).
  3. REMOVE FRONT SEAT ASSEMBLY  (See REMOVAL )
  4. REMOVE RECLINING POWER SEAT SWITCH KNOB  (See DISASSEMBLY )
  5. REMOVE SLIDE AND VERTICAL POWER SEAT SWITCH KNOB  (See DISASSEMBLY )
  6. REMOVE FRONT SEAT CUSHION SHIELD ASSEMBLY  (See DISASSEMBLY )
  7. REMOVE SEAT SLIDE POSITION SENSOR PROTECTOR 
    1. Remove the seat slide position sensor protector from the seat position sensor.
  8. REMOVE SEAT POSITION SENSOR 
    1. Disconnect the connector from the seat position sensor.
      Fig 1: Identifying Seat Slide Position Sensor Protector And Seat Position Sensor
      G05005343Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
    2. Using a "torx" socket wrench (T30), remove the "torx" screw and the seat position sensor.
scientia non olet · About LEMON Manuals