LEMON Manuals: Even more car manuals for everyone
Home >> Lexus >> 2004 >> RX 330 FWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 599 (Supplemental Restraint System) >> Center Airbag Sensor Assembly >> Removal

Center Airbag Sensor Assembly: Removal

WARNING: This page is about a different car, the 2008 Lexus RX 350. However, it is still accessible from the selected car via links, so may be relevant.
  1. PRECAUTION 
    CAUTION: Be sure to read the "PRECAUTION" thoroughly before servicing (See PRECAUTION  ).
  2. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL 
    CAUTION: Wait for 90 seconds after disconnecting the cable to prevent the airbag working.
    NOTE: When disconnecting the cable, some systems need to be initialized after the cable is reconnected (See INITIALIZATION ).
  3. REMOVE FRONT SEAT ASSEMBLY  (See REMOVAL )
  4. REMOVE CONSOLE PANEL UPPER FRONT (See  REMOVAL  ) 
  5. REMOVE INSTRUMENT PANEL FINISH PANEL LOWER (See  REMOVAL  ) 
  6. REMOVE FRONT DOOR SCUFF LH PLATE  (See REMOVAL )
  7. REMOVE INSTRUMENT PANEL FINISH PANEL SUB-ASSEMBLY LOWER (See  REMOVAL  ) 
  8. REMOVE FRONT DOOR SCUFF RH PLATE 

    HINT:

    Use the same procedures for the front door scuff RH plate and the front door scuff LH plate.

  9. REMOVE FRONT DOOR OPENING TRIM RH WEATHERSTRIP 
  10. REMOVE COWL SIDE TRIM SUB-ASSEMBLY RH 

    HINT:

    Use the same procedures for the cowl side trim sub-assembly RH and the cowl side trim sub-assembly LH (See REMOVAL ).

  11. REMOVE INSTRUMENT PANEL NO.2 UNDER COVER SUB-ASSEMBLY (See  REMOVAL  ) 
  12. REMOVE GLOVE COMPARTMENT DOOR ASSEMBLY (See  REMOVAL  ) 
  13. REMOVE FLOOR CARPET COVER CENTER LH (See  REMOVAL  ) 
  14. REMOVE FLOOR CARPET COVER CENTER RH 

    HINT:

    Use the same procedures for the floor carpet cover center RH and the floor carpet cover center LH.

  15. REMOVE INSTRUMENT PANEL FINISH PANEL LOWER CENTER (See  REMOVAL  ) 
  16. REMOVE CONSOLE BOX HOLE COVER (See  REMOVAL  ) 
  17. REMOVE CONSOLE BOX NO.2 HOLE COVER 

    HINT:

    Use the same procedures for the console box No.2 hole cover and the console box hole cover.

  18. REMOVE REAR CONSOLE BOX (See  REMOVAL  ) 
  19. REMOVE CONSOLE BOX NO.1 DUCT 
  20. REMOVE CONSOLE COVER LOWER 
    1. Remove the 2 screws.
    2. Disconnect the connector and remove the console cover lower.
      3. Fig 1: Identifying Console Cover Lower Screws
      G05270423Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
  21. REMOVE AIR DUCT REAR NO.2  (See REMOVAL )
  22. REMOVE AIR DUCT REAR NO.1  (See REMOVAL )
  23. REMOVE CENTER AIRBAG SENSOR ASSEMBLY 
    1. Disconnect the 3 connectors from the center airbag sensor assembly.
    2. Remove the 3 bolts and the center airbag sensor assembly.
      Fig 2: Locating Center Airbag Sensor Assembly Bolts
      G05270424Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
scientia non olet · About LEMON Manuals