LEMON Manuals: Even more car manuals for everyone
Home >> Lexus >> 2004 >> RX 330 AWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 577 (Charging) >> Generator >> Removal

Section 577 (Charging): Generator: Removal

WARNING: This page is about a different car, the 2008 Lexus RX 350. However, it is still accessible from the selected car via links, so may be relevant.
  1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL 
  2. REMOVE FRONT WHEEL RH 
  3. REMOVE NO. 1 ENGINE UNDER COVER 
  4. REMOVE FRONT FENDER SPLASH SHIELD SUB-ASSEMBLY RH 
  5. REMOVE FRONT FENDER APRON SEAL RH 
  6. REMOVE ENGINE ROOM COVER SIDE  (See REMOVAL )
  7. REMOVE V-BANK COVER SUB-ASSEMBLY  (See REMOVAL )
  8. REMOVE COOL AIR INTAKE DUCT SEAL  (See REMOVAL )
  9. REMOVE NO. 2 AIR CLEANER INLET  (See REMOVAL )
  10. REMOVE AIR CLEANER CAP SUB-ASSEMBLY  (See REMOVAL )
  11. REMOVE NO. 1 AIR CLEANER INLET  (See REMOVAL )
  12. DISCONNECT RADIATOR RESERVOIR TANK HOSE  (See REMOVAL )
  13. REMOVE HOOD LOCK CONTROL CABLE COVER  (See REMOVAL )
  14. REMOVE HOOD LOCK ASSEMBLY  (See REMOVAL )
  15. REMOVE UPPER RADIATOR SUPPORT SUB-ASSEMBLY  (See REMOVAL )
  16. REMOVE FAN SHROUD  (See REMOVAL )
  17. REMOVE V-RIBBED BELT  (See REMOVAL )
  18. REMOVE GENERATOR ASSEMBLY 
    1. Remove the terminal cap.
    2. Remove the nut and disconnect the wire harness from terminal B.
    3. Disconnect the generator connector from the generator assembly.
      Fig 1: Identifying Generator Connector & Generator Assembly
      G05268547Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
    4. Disconnect the connector from the compressor and magnetic clutch.
    5. Disconnect the 2 wire harness clamps.
    6. Remove the 2 bolts.
      Fig 2: Identifying Generator Bolts
      G05268548Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
    7. Remove the bolt from the cylinder block.
      Fig 3: Identifying Cylinder Block Bolt
      G05268549Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
    8. Disconnect the wire harness clamp and remove the generator assembly.
    9. Remove the bolt and wire harness clamp stay.
      Fig 4: Identifying Wire Harness Clamp Stay Bolts
      G05268550Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
    10. Remove the bolt and bracket.
      Fig 5: Identifying Bolt & Bracket
      G05268551Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
scientia non olet · About LEMON Manuals