Rear Axle Hub Bolt: Replacement

HINT:

Replace the RH side using the same procedures as for the LH side.

1. REMOVE REAR WHEEL 
2. SEPARATE REAR DISC BRAKE CALIPER ASSEMBLY LH 
   1. Separate rear disc brake caliper assembly LH for 2WD (see REMOVAL  ).
3. SEPARATE REAR DISC BRAKE CALIPER ASSEMBLY LH 
   1. Separate rear disc brake caliper assembly LH for 4WD (see REMOVAL  ).
4. REMOVE REAR DISC 
5. REMOVE REAR AXLE LH HUB BOLT 
   1. Temporarily install the 2 nuts and washers to the rear axle LH hub bolt as shown in the illustration.
   2. Using SST(s) and a hammer handle or an equivalent to hold the hub & bearing assembly, remove the rear axle LH hub bolt.

      SST 09628-10011 

      Fig 1: Removing Rear Axle LH Hub Bolt

      Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
6. INSTALL REAR AXLE LH HUB BOLT 
   1. Install a washer and nut to a new bolt.
   2. Using a hammer handle or an equivalent to hold the hub & bearing assembly, install the rear axle LH hub bolt by tightening the nut.
      Fig 2: Installing Rear Axle LH Hub Bolt

      Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
7. INSTALL REAR DISC 
8. INSTALL REAR DISC BRAKE CALIPER ASSEMBLY LH 
   1. Install rear disc brake caliper assembly LH for 2WD (see INSTALLATION  ).
9. INSTALL REAR DISC BRAKE CALIPER ASSEMBLY LH 
   1. Install rear disc brake caliper assembly LH for 4WD (see INSTALLATION  ).
10. INSTALL REAR WHEEL 

    Torque: 103 N*m (1,050 kgf cm, 76 ft.*lbf)