Height Control Valve Sub-ASSY No.1: Replacement

REMOVE FRONT WHEELS
REMOVE FRONT FENDER LINER LH
REMOVE HEIGHT CONTROL VALVE SUB-ASSY NO.1
1. Disconnect the connector.
2. Disconnect the under side air tube (see PRECAUTION ).
3. Disconnect the 3 side air tubes (see PRECAUTION ).
4. Remove the 2 nuts and height control valve sub-assy No.1.
  
  Fig 1: Disconnecting Under Side Air Tube
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
INSTALL HEIGHT CONTROL VALVE SUB-ASSY NO.1
1. Install the height control valve sub-assy No.1 with 2 nuts.
  Torque: 5.4 N.m (55 kgf.cm, 48 in. lbf)
2. Connect the 3 side air tubes (see PRECAUTION ).
3. Connect the under side air tube (see PRECAUTION ).
4. Connect the connector.
  
  Fig 2: Installing Height Control Valve Sub-Assembly
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
INSTALL FRONT FENDER LINER LH
INSTALL FRONT WHEELS
Torque: 103 N.m (1,050 kgf.cm, 76 ft.lbf)
INSPECT AIR LEAK (SEE ON-VEHICLE INSPECTION )