Wheel Opening Molding: Replacement

WARNING: This page is about a different car, the 2004 Lexus SC 430. However, it is still accessible from the selected car via links, so may be relevant.

HINT:

The installation procedures are the removal procedures in reverse order.
Use the same procedures for the RH side and LH side.
The procedures listed below are for the LH side.

REMOVE FRONT FENDER WHEEL OPENING MOLDING LH
1. Remove the 5 screws.
2. Using a screwdriver, pry off the wheel opening molding and remove it.
  HINT:
  
  Tape the screwdriver tip before use.
REMOVE QUARTER PANEL WHEEL OPENING MOLDING LH
1. Remove the 5 screws.
2. Using a screwdriver, pry off the molding and remove it.
  HINT:
  
  Tape the screwdriver tip before use.