On-Vehicle Inspection

INSPECT CONDENSER FAN OPERATION
Inspect the fan operation, as shown in the chart below.

Test conditions:

Engine coolant temperature "Below 82 °C (180 °F)"

Fig 1: Condenser Fan Operation Condition Specifications
Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

If operation is not as specified, proceed next inspection.
INSPECT CONDENSER FAN MOTOR OPERATION
1. Remove air inlet duct.
2. Disconnect the 2 connector.
3. Connect battery and ammeter.
4. Check that the fan rotates smoothly, and then check the reading on the ammeter.
Fig 2: Inspecting Condenser Fan Motor Operation
Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

Specified Amount: 9.2-11.0 A at 20 °C (68°F)

If operation is not as specified, replace the fan motor.
INSPECT COOLING FAN COMPUTER WIRE HARNESS
1. Remove air inlet duct.
2. Disconnect the 2 connector.
3. Inspect the connector on wire harness side.
4. Measure voltage between terminals 1 and 3.
Voltage: 9-14 V

If operation is not as specified, check the fuse, relay and wire harness.

If operation is as specified, replace the cooling fan computer.