LEMON Manuals: Even more car manuals for everyone
Home >> Lexus >> 2003 >> LS 430 >> Repair and Diagnosis >> External Pages >> Different car >> Section 490 (Engine Immobilizer System - Diagnostics) >> How To Proceed With Troubleshooting

How To Proceed With Troubleshooting

WARNING: This page is about a different car, the 2004 Toyota 4Runner. However, it is still accessible from the selected car via links, so may be relevant.

HINT:

Troubleshoot in accordance with the procedures in the following.

  1. VEHICLE BROUGHT TO WORKSHOP 
  2. CUSTOMER PROBLEM ANALYSIS CHECK AND PROBLEM SYMPTOM CONFIRMATION 
  3. CRANK ENGINE FOR MORE THAN 10 SECONDS 
  4. CHECK DIAGNOSTIC TROUBLE CODE 
    1. Check for a DTC.
      1. When any of code B2780, B2784, B2794, B2795, B2796, B2797, B2798 or B2799 is output, proceed to A.
      2. When a code except B2780, B2784, B2794, B2795, B2796, B2797, B2798 or B2799 is output, proceed to B.

    B: GO TO SFI SYSTEM (See  SFI SYSTEM (2UZ-FE) - DIAGNOSTICS  or See  SFI SYSTEM (1GR-FE) - DIAGNOSTICS  ) 

    A: Go To Next Step 

  5. READ VALUE OF HAND-HELD TESTER (IMMOBILIZER ECU (TRANSPONDER KEY ECU ASSY) (SWITCH CONDITION) 
    1. Connect the hand-held tester to the DLC3.
    2. Turn the ignition switch ON and push the hand-held tester main SW ON.
    3. Select the item "KEY SW" in the "DATA LIST" and read its value displayed on the hand-held tester.

    TRANSPONDER KEY ECU: 

    Fig 1: Transponder Key ECU
    G02835478Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

    NG: GO TO DTC B2780 (See  DTC B2780 PUSH SWITCH/KEY UNLOCK WARNING SWITCH MALFUNCTION CIRCUIT DESCRIPTION  ) 

    OK: Go To Next Step 

  6. CHECK DIAGNOSTIC TROUBLE CODE OF TRANSPONDER KEY ECU ASSY 
    1. Check for a DTC and make a note of the code that is output.
    2. Delete the DTC.
    3. Check if the DTC will be output once again, when the problem symptom is simulated based on the noted code.
    1. Without an output of the code, proceed to A.
    2. With an output of the code, proceed to B.

    B: Go to step   8 

    A: Go To Next Step 

  7. PROBLEM SYMPTOMS TABLE (See  PROBLEM SYMPTOMS TABLE  ) 
    1. Without an applicable problem symptoms table, proceed to A.
    2. With an applicable problem symptoms table, proceed to B.

    B: Go to step   9 

    A: Go To Next Step 

  8. ACCORDING TO PROBLEM SYMPTOM, PERFORM TROUBLESHOOTING 
    1. Pre-check (See PRE-CHECK )
      1. Inspect with the hand-held tester (ECU data monitor).
      2. Inspect with the hand-held tester (Active test).
    2. Terminals of ECU (See TERMINALS OF ECU )
  9. ADJUST, REPAIR OR REPLACE END 

    END 

scientia non olet · About LEMON Manuals